Wire Mesh Fence for everyone is a strange and familiar words, previously introduced fence, do not know if you still have the impression. The following summarizes the Wire Mesh Fence mainly refers to the use of metal - low carbon steel wire and Q235 welded steel mesh fence. Mainly divided into two-sided wire fence, frame fence, peach-shaped column fence, and so on, each of which is divided into many types, mainly used in highways, gardens, orchards, nursery, railways, bridges, schools, Stadiums, factories, residential quarters, organs and units, industrial parks, logistics parks, etc., each corner of each area can see the existence of metal mesh fence.
Wire Mesh Fence
Today is the main introduction of the installation of Wire Mesh Fence. There are two main installation methods, one is embedded, one is with a flange, playing expansion bolts. Embedded is the column to do more than 30-60 cm higher than the mesh, and then 5-15 cm away from the ground outside, buried in the land, apply to land. This is very strong, the life of the wire mesh fence has a great impact. The other is the column with a flange, and then hit the expansion bolts fixed, so the main applies to the lime, that is, the ground is relatively hard, so as to be able to support the weight of the column and the pressure of the mesh.
Wire Mesh Fence installation method of the first: If the ground is a natural land, then the Wire Mesh Fence column in general on the basis of the original extension of 30 cm, digging on the ground about 30 cm * 30 cm * 50 cm deep pit, put the column into, And then poured with cement stones. And then measure the width of the mesh, find the next location, install the next column. Wait until the column to dry well after the fixed, with anti-theft bolts fixed mesh.
Wire Mesh Fence installation method of the second: the ground if it is lime, then, in the column of the Department, welded square flange, with the expansion screw to the column fixed on the ground. And then measure the width of the wire mesh fence mesh, find the next location, install the next column. Then fix the mesh with anti-theft bolts.
1. Measurement lofting: according to the design requirements and the actual terrain, the situation of the ground for the construction of lofting, set the column center line, according to the provisions of the slope and linear installation fence.
2. Column fixed fixed section, with the expansion of the fixed ends of the column, from the vertical view, the column axis in a straight line, there should be no uneven phenomenon; from the height of the column top smooth, should not appear rugged Except for special terrain.
3. The installation process must ensure the stability of the column, and closely connected to the base of the column to install the installation, the small line of flatness detection process, part of the adjustment to ensure that the straight line and curve section,Wire Mesh Fence in accordance with the requirements of the design drawings fixed. In the latter part of the construction, the supervision engineer to the column for a high degree of detection, as well as the connection stability and stability of the test, in accordance with the requirements of the requirements, before construction.